Run Stop Re-Store
- Utrechtseweg 47H, Utrecht, Netherlands
- info@runstoprestore.nl
- Run Stop Re-Store
- 82010056
- NL003628252B79
- KNAB
- NL56KNAB0617736316
-
MOS901482-03 DOS 2.5 ROM for the Commodore 8050 (New Old Stock)
MOS901482-07 DOS 2.5 for the Commodore 8050 drives
New old stock, date codes may vary
Price includes EU Tax
€19,95 -
MOS315079-01 German/DE Character ROM for the Commodore 128 (New Old Stock)
MOS315079-01 German/DE Character ROM for the Commodore 128.
New old stock, date codes may vary
Price includes EU Tax
€14,95 -
MOS251968-03 DOS/Kernal ROM for the Commodore 1541-II (New Old Stock)
MOS251968-03 DOS/Kernal ROM Commodore 1541-II diskdrive.
New old stock, date codes may vary
Price includes EU Tax
€9,95 -
MOS251968-01 DOS/Kernal ROM for the Commodore 1541C (New Old Stock)
MOS251968-01 DOS/Kernal ROM Commodore 1541C diskdrive.
New old stock, date codes may vary
Price includes EU Tax
€9,95 -
MOS901887-01 DOS 2.7 ROM for the Commodore SFD-1001 (New Old Stock)
MOS901887-01 DOS 2.7 ROM Commodore SFD-1001 diskdrive.
New old stock, date codes may vary
Price includes EU Tax
€9,95 -
MOS901888-01 DOS 2.7 ROM for the Commodore SFD-1001 (New Old Stock)
MOS901888-01 DOS 2.7 ROM Commodore SFD-1001 diskdrive.
New old stock, date codes may vary
Price includes EU Tax
€9,95 -
MOS6523T Tri-Port interface for the 1551 Paddle (New Old Stock)
The extremely hard to find MOS6523T Tri-Port interface for the Commodore 1551 Paddle.
New old stock, date code 1285
Very limited stock, one chip per customer.
Price includes EU Tax
€99,00 -
LAG570 Motor Control IC for 15×1 drives (New Old Stock)
If your 15×1 drive experiences speed alignment issues, it’s very likely the LAG570 chip is the issue.
New old stock, date codes may vary.
Price includes EU Tax
€7,95 -
MOS318022-02 DOS 7 ROM for the Commodore 128D (New Old Stock)
MOS318022-02 DOS 7 ROM Commodore 128D.
New old stock, date codes may vary
Price includes EU Tax
€14,95 -
MOS380630-01 CIA (U17) for the Amiga A1060 Sidecar (New Old Stock)
MOS380630-01 CIA (U17) for the Commodore Amiga A1060 Sidecar.
New old stock, date codes may vary
Price includes EU Tax
€14,95 -
MOS318018-02 Basic Low ROM for the C128 (New Old Stock)
MOS18018-02 Basic Low ROM for the Commodore 128.
New old stock, date codes may vary
Price includes EU Tax
€7,50 -
MOS318019-02 Basic High ROM for the C128 (New Old Stock)
MOS18019-02 Basic High ROM for the Commodore 128.
New old stock, date codes may vary
Price includes EU Tax
€7,50 -
Toshiba TC514256AZ-70 256kx4bits 128KB ZIP RAM (New Old Stock)
Toshiba TC514256AZ-70 256kx4bits, 128KB per chip ZIP RAM. Used in many 6 bit era machines, e.g. Amiga 3000, Videotoaster, memory expansions etc..
New old stock, date codes may vary
Price includes EU Tax
€4,95 -
MOS380620-01 FPLA1 (U39) for the Commodore A1060 Sidecar (New Old Stock)
MOS380620-01 FLPA1 (U39) for the Commodore A1060 Sidecar.
New old stock, date codes may vary
Price includes EU Tax
€29,95 -
MOS380621-01 FPLA2 (U40) for the Commodore A1060 Sidecar (New Old Stock)
MOS380621-01 FLPA2 (U40) for the Commodore A1060 Sidecar.
New old stock, date codes may vary
Price includes EU Tax
€29,95 -
J-CPU64 6510/8500 replacement for the Commodore 64
The J-CPU64 has arrived!
- The long awaited MOS/CSG 6510/8500 CPU replacement is here! Jani’s second major hardware product after the very successful J-CIA64 comes in the form of the J-CPU64.
- Limited first batch stock, all pre-orders will be fulfilled first starting shipping from May 16th onwards.
Description and features:
- FPGA based replacement for MOS/CSG 6510 & 8500 CPU chips.
- Lower power requirements, less heat! Actually; not discernible heat at all.
- Complete logic and all features of the original IC implemented, including illegal opcodes for maximum compatibility with all your favorite games and demos.
- All diagnostic & software tests passed 100%, including all tests in Wolfgang Lorenz’s test suite and Vice-project’s CPU-tests.
- Hundreds of demos and games already tested, with no known compatibility issues in tons of different configurations.
- Physically about the same size as the original CPU and drops right in place of the original chip without any board modifications or soldering required.
- Tested with all C64 mainboard revisions, SX-64 and with modern clones like the EVO64, Blue Pearl and the iComp’s Reloaded MKII.
- Tested with modern chip replacements like the VIC-II Kawari, PLA replacements like PLAnkton, NeatPLA etc, and of course J-CIA.
- Load of peripheral hardware tested and found to be compatible including (but not limited to) different types of floppy drives, fast loaders, Ultimate-II+, SD2IEC, TapeCart, Kung-Fu Flash, EasyFlash, Tapuino and more.
- Specially designed clock out signal circuitry (PHI2) for super strong and stable clock signals, with sharp rising and falling signal edges ensuring maximum stability and compatibility.
For EU customers, price listed includes applicable VAT rate
€39,95 -
Space Saver Pro
The SpaceSaver Pro cable for the C64 and VIC20 CR* Â is THE solution to the inefficient use of space that traditional power cables cause by connecting to the power-plug in a straight line. Because of the elbow design, the power-cable leaves the computer at a 90 degree angle towards the back, reducing the cable footprint dramatically.
This high quality cable not only is fully injection moulded, it also has a built-in overvoltage protector on the 5V supply, to avoid damage by faulty power supplies. A small window in the connector allows you to see the led indicator, where green means all is ok, but red indicates an overvoltage. Whenever the 5V rail goes over the 5.4V threshold, the circuit inside will cut the power within nanoseconds, to prevent any harm to the chips inside your beloved machine.
Your power supply plugs right into the female DIN connector, and the 30cm long 20AWG grade wiring in between the connectors makes sure this cable can handle currents up to 3.5A. A grippy surface makes plugging in and removing the cable easy, avoids stress on the internal cable joints, and there is enough clearance to accommodate the many variances in case/socket depth, which prevents the cable casing from putting permanent stress on the power socket.
*The VIC20 CR (cost reduced) version uses the same power connector as the C64, and has a separate +5V rail which is susceptible to overvoltage from a bad PSU.
See the extend product description below for more details.
For EU customers, price listed includes applicable VAT rate
€17,95Space Saver Pro
€17,95 -
SPL HD-64 mounting bracket
High quality 3D printed mounting bracket with brass screw inserts for the SPL HD-64 HDMI modulator.
The bracket fits both longboards and shortboards.
Includes 3xm2 (longboard) and/or 3xm1.4 (shortboard) screws for the bracket to C64 pcb fixt and 4xm3 metal screws for the HD-64 to bracket fix.
-
J-CPU264 8501 CPU replacement for the C16. Plus/4 & 116
The J-CPU264 is now available!
- The long awaited MOS/8501 CPU replacement is here! Aonther great hardware product after the very successful J-CIA64 and J-CPU64 comes in the form of the J-CPU264.
- Limited first batch stock.
Description and features:
- FPGA based replacement for MOS8501 CPU chips, used in the C16 , Plus/4 and the C116 (the TED model series).
- Lower power requirements, less heat! Actually; not discernible heat at all.
- Complete logic and all features of the original IC implemented, including illegal opcodes for maximum compatibility with all your favorite games and demos.
- All diagnostic & software tests passed 100%, includingthe most demanding games, demos and peripherals like the UltimateII+ and Diag264.
- No known compatibility issues in tons of different configurations.
- Physically about the same size as the original CPU and drops right in place of the original chip without any board modifications or soldering required. In the 116 you may need to isolate the top of the J-CPU264 from the shielding.
- Tested with all TED series machines, incl expanded memory configs.
For EU customers, price listed includes applicable VAT rate
€39,95 -
Cartridge Port connector for the Commodore64/128
Brand new cartidge port connector for the Commodore 64/128.
€5,00 -
The WOPR64
“Greetings Professor Falken. Shall we play a game?”
WOPR64 – Start World War III with your C64!
The coolest cartridgeport extender available inspired by the 80’s classic cult movie WarGames.Now back in limited supply! Comes with standoffs
A case is sold separately by Arcadia: https://www.retro8bitshop.com/product/wopr64-casing-blue-version/
€29,95The WOPR64
€29,95 -
J-PLA for the Commodore 64
- A new PLA replacement, brought to you by Jani, the man from J-CIA64 and J-CPU(2)64 fame.
- Slick drop in replacement for the PLA, compatible with all longboard revisions.
- 100% compatible with all known games, demos and hardware peripherals.
€22,95J-PLA for the Commodore 64
€22,95
